Audiovox PRO9776C Manuale di Installazione Scaricare il pdf (Pagina 18)

128-8787b

18 of 32

and fluids warm. The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48

hours. Factory preset is to start at 4 hour intervals. To select 2 or 4 hour automatic start timer:

1. Start By Holding the Push Button Switch found on the windshield mount receiver on.

2. While Holding the Push Button Switch Turn The Ignition Switch On Then Off

3a. Within 10 seconds of turning the ignition switch off, Release and then Push On and release the Push

Button Switch 2 times holding it on the second time until the siren and or lights flash and chirp 2

times indicating that the 2 Hour Start Interval has successfully been set. or

3b. Within 10 seconds of turning the ignition switch off, (Step 2) Release and then Push On and release

the Push Button Switch 4 times holding it on the fourth time until the siren and or lights flash and

chirp 4 times indicating that the 4 Hour Start Interval has successfully been set.

NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. To

change, the above sequence will have to be followed.

TIMED START OPERATION:

To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF command to start

2 times. (Press the start button four times). The lights will flash and the siren will chirp 4 times, indicating the

timed interval mode has been initiated. The vehicle will automatically start every 2 or 4 hours as programmed.

To cancel the timed start mode start the vehicle either by RF or by the ignition key.

DIESEL ENGINE SETTINGS:

NOTE: When selecting Diesel operation, (Bank 3 Feature #11), over gasoline, the only change is to the

ignition circuits. When Diesel is selected, the ignition circuits will power up 10, 15, or 20 seconds before

the start circuit. The intent of this feature is to allow the glow plug warming required by some diesel

engines. If your vehicle is a instant start diesel, it is not necessary to activate this feature.

ALSO: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be

certain to connect the tach input wire. Also note, if the "Diesel Wait to Start" input is connected,

(Green/Yellow) this wire will take precedence over the Diesel selection of bank 3 feature 11.

Monitoring The Vehicle's Engine: (Program Feature #5 Bank 3)

There are 4 ways that the remote start monitors the engine running, one or the other must be selected for

your application for the remote start to operate correctly.

1) VOLTAGE SENSE SETTING:

The unit will monitor the voltage level of the battery during remote start, wait for the voltage to drop while

cranking, then look for the voltage level to go above the level it was before the vehicle began to crank which

indicates the vehicle is running. Feature #14 of Bank 3 must be set for preset time or the voltage sense

feature will not operate indicated by the parking lights flashing 7 times.

2) TACH RATE SETTING:

1. Turn the ignition key to the On position.

2. Press and release the valet/program push button switch 3 times.

3. Immediately turn the ignition key Off.

4. Press and hold the valet/program push button switch, then start the vehicle using the key.

5. When the unit senses the tach signal, the parking lights will begin to flash.

6. Release the valet/program pushbutton switch. The parking lights will turn on for three seconds to indicate

that the learned tach signal is stored and the unit is out of the tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach source, the

parking lights will not flash. To correct this situation, locate and connect the Green/Orange wire to

the proper tach signal, and then repeat the tach learn routine.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Commenti su questo manuale

Nessun commento

Audiovox PRO9776C Manuale di Installazione Pagina 18

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Audiovox PRO9776C