Audiovox APS-997C Manuale di Installazione Scaricare il pdf (Pagina 13)

128-8775b

13 of 32

D. Anti-Grind Starter Circuit Connection:

This wire, when connected to a starter inhibit relay, as shown in the diagram below, will prevent the

customer from engaging the starter while the vehicle is running under control of the remote start.

Configured in this way, while the remote start is controlling the vehicle, the light blue wire has ground on

it all the time. This ground will cause the relay to energize preventing current flow through the normally

closed contacts. This will prevent a customer who inadvertently turns the ignition switch to the start

position, from sending current to the starter.

22 Orange w/ White Trace Wire : 300 mA (-) Output When Disarmed

N. O. Starter Disable Circuit, (Optional Relay Required).

This wire is provided to control a normally open starter cut relay. Connect the orange/white wire to terminal

86 of the relay. Connect relay terminal 85 to an ignition wire in the vehicle that is live when the key is in the

on and crank positions, and off when the key is in the off position. ( This is typically an ignition 1 source),

Cut the low current starter solenoid wire in the vehicle, and connect the car side of the cut wire to relay

terminal 87. Connect the key side of the cut wire to relay terminal 30.

NOTE: This is a normally opened starter cut arrangement, when power is removed from the secu-

rity system, the starter disable feature will remain operational, and the vehicle will not start.

Audiovox does not recommend using the Orange w/ White trace wire to interrupt anything but the

starting circuit of the vehicle.

23 Orange Wire: 300mA (-) Ground When Armed Output

This wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibit

relay. Connect the Orange wire to terminal #86 (orange wire) of the relay provided. Connect terminal #85

(red wire) of the relay to an ignition wire in the vehicle that is +12 volts when the ignition switch is turned

to the on and start positions and off when the key is off. Locate and cut the low current start solenoid

wire found at the vehicles ignition switch harness. This wire will have + 12 volts when the ignition key is

moved to the start (crank) position and will have 0 volts in all other key positions. Connect one side of

the cut wire to terminal #87a ( Black wire) of the relay. Connect the other side of the cut wire to terminal

#30 (White/Black wire) of the relay. See below for detail of wiring, also see Yellow Start wire detail for

connection to vehicle considerations.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Nessun commento

Audiovox APS-997C Manuale di Installazione Pagina 13